Elzinga soil
Wild-clay potential
Weak indication
Weak indication: no layer of Elzinga shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Elzinga soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Elzinga spot on the map
Rated from the USDA soil survey record for Elzinga-Maughan complex, 25 to 50 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (7.5).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 29 in (74 cm)).
- Note Typically starts about 24 in (61 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 40% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
- Note Surface layer; expect roots and organic matter.
Layer by layer
- TopsoilA11 A silt loam layer about 0 to 10 in down: about 23% clay, moderate plasticity when wet, very dark gray when moist. Weak indication
- TopsoilA12 A loam layer about 10 to 24 in down: about 23% clay, moderate plasticity when wet, very dark gray when moist. Weak indication
- TopsoilA2best layer A very gravelly silt loam layer about 24 to 53 in down: about 23% clay, moderate plasticity when wet, very dark gray when moist. Weak indication
- Loamy layerB2t A very gravelly clay loam layer about 53 to 64 in down: about 32% clay, moderate plasticity when wet, the e portion is pale brown when moist. Weak indication
What it looks like raw
The topsoil (A2), 24 to 53 in down in the typical profile: very dark gray (10YR 3/1), black (10YR 2/1) moist; soft, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium and colluvium derived from quartzite and sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Box Elder County, Utah, Eastern Part.
By state: wild clay in Utah.
USDA, distribution and extent: Elzinga soils are of small extent in northern Utah; MLRA
USDA, geographic setting: Landform--very steep north or northeast facing mountain slopes
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Collett: Strong lead
- Eimarsh: Strong lead
- Goring: Strong lead
- Lasil: Strong lead
- Manila: Strong lead
- Obray: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
See it on the map
Open a Elzinga spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Elzinga-Maughan complex, 25 to 50 percent slopes, map unit ENF in Box Elder County, Utah, Eastern Part.
- Official Series Description: Elzinga(revised 01/2023), established.
- Taxonomic class: Fine-loamy, mixed, superactive, frigid Pachic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.