Doylestown soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 28 to 65 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Doylestown soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Doylestown spot on the map
Rated from the USDA soil survey record for Doylestown silt loam, 0 to 3 percent slopes (Montgomery County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 27% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Btx" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (18).
- Note The official series description calls the wet soil moderately sticky and slightly plastic.
- Note Thick enough to investigate (about 37 in (94 cm)).
- Note Typically starts about 28 in (71 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 14% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 6 in down: about 25% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBtg A silt loam layer about 6 to 28 in down: about 27% clay, moderate plasticity when wet, gray when moist. Possible
- Clay subsoilBtxbest layer A silt loam layer about 28 to 65 in down: about 27% clay, moderate plasticity when wet, reddish brown when moist. Possible
What it looks like raw
The clay subsoil (Btx), 28 to 65 in down in the typical profile: reddish brown (5YR 4/3), and strong brown (7.5YR 5/8); very firm, brittle, sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: eolian deposits over residuum weathered from shale and siltstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: poorly drained.
- Lithic bedrock typically about 66 in (167 cm) down.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Pennsylvania, in these survey areas: Bucks County, Pennsylvania; Montgomery County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Southeastern Pennsylvania, New Jersey and Maryland. The series is of moderate extent.
USDA, geographic setting: Doylestown soils are on nearly level and gently sloping upland flats and depressions. Slopes range from 0 to 8 percent. These soils formed in silty materials, presumably eolian, deposited over a wide variety of material weathered from shale, sandstone, limestone, schist and gneiss. The climate is humid temperate, with mean annual precipitation of 38 to 48 inches, mean annual air temperatures of 50 to 55 degrees F., and a growing season of 170 to 200 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Watchung: Strong lead
- Bowmansville: Promising
- Croton: Promising
- Hatboro: Promising
- Mount Lucas: Promising
- Raritan: Promising
- Readington: Promising
- Rowland: Promising
See it on the map
Open a Doylestown spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Doylestown silt loam, 0 to 3 percent slopes, map unit DsA in Montgomery County, Pennsylvania.
- Official Series Description: Doylestown(revised 01/2006), established.
- Taxonomic class: Fine-silty, mixed, active, mesic Typic Fragiaqualfs
- Rated with rule version 2026-09-28.1; the method is on the About page.