Desmet soil
Wild-clay potential
Weak indication
Weak indication: no layer of Desmet shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Desmet soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Desmet loam, 0 to 2 percent slopes (Missoula County Area, Montana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 14% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 21 in (53 cm)).
- Note Typically starts about 39 in (99 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 12% by volume).
- Note USDA reports about 9% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilAp A loam layer about 0 to 7 in down: about 14% clay, low plasticity when wet, grayish brown when moist. Weak indication
- TopsoilA A loam layer about 7 to 15 in down: about 14% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerBk A loam layer about 15 to 24 in down: about 14% clay, low plasticity when wet, light gray when moist. Weak indication
- Sandy layerBC1 A very fine sandy loam layer about 24 to 39 in down: about 14% clay, low plasticity when wet, light gray when moist. Weak indication
- Sandy layerBC2best layer A very fine sandy loam layer about 39 to 60 in down: about 14% clay, low plasticity when wet, light gray when moist. Weak indication
What it looks like raw
The sandy layer (BC2), 39 to 60 in down in the typical profile: light gray (2.5Y 7/2), grayish brown (2.5Y 5/2) moist; slightly hard, very friable, nonsticky, nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Montana, in these survey areas: Missoula County Area, Montana.
By state: wild clay in Montana.
USDA, distribution and extent: Desmet soils are of small extent in mountain valleys of western Montana.
USDA, geographic setting: Desmet soils are on terraces in intermountain valleys. Elevations are 2,800 to 3,500 feet. Slopes are 0 to 2 percent. These soils formed in alluvium. The climate is characterized by long, cold winters, moist springs; and warm, dry summers. Mean annual precipitation is 11 to 14 inches, much of which falls as snow or as spring rain. Mean annual temperature is 43 to 45 degrees F. The frost-free period is 105 to 120 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Crow: Strong lead
- Grassvalley: Strong lead
- Half Moon: Promising
- Bignell: Possible
- Burnt Fork: Possible
- Greenough: Possible
- Minesinger: Possible
- Alberton: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Desmet loam, 0 to 2 percent slopes, map unit 34 in Missoula County Area, Montana.
- Official Series Description: Desmet(revised 11/2002), established.
- Taxonomic class: Coarse-silty, mixed, superactive, frigid Calcidic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.