Dangulch soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 7 to 15 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Dangulch soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Dangulch spot on the map
Rated from the USDA soil survey record for Dangulch silt loam, 25 to 50 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 44% clay in the fine-earth portion.
- Note USDA labels this a "Bt2" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (32): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 8 in (20 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 9.7%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA A silt loam layer about 0 to 5 in down: about 24% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBt1 A silty clay loam layer about 5 to 7 in down: about 33% clay, high plasticity when wet, dark grayish brown when moist. Possible
- Clay subsoilBt2best layer A clay layer about 7 to 15 in down: about 44% clay, high plasticity when wet, brown when moist. Strong lead
- Clay subsoilBtk A silty clay loam layer about 15 to 21 in down: about 29% clay, high plasticity when wet, very pale brown when moist. Promising
- Loamy layerBk1 A silt loam layer about 21 to 29 in down: about 19% clay, moderate plasticity when wet, very pale brown when moist. Possible
- Sandy layerBk2 A loam layer about 29 to 48 in down: about 16% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
- BedrockCr Bedrock about 48 to 58 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Bt2), 7 to 15 in down in the typical profile: brown (10YR 5/3), brown (10YR 4/3) moist; very hard, firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: silty lacustrine deposits.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: well drained.
- Paralithic bedrock typically about 48 in (122 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern Idaho. MLRA 10. Dangulch soils are not extensive.
USDA, geographic setting: Dangulch soils are steep on hill backslopes at elevations of 2,750 to 3,900 feet. Slopes range from 25 to 50 percent. These soils formed in colluvium from lacustrine deposits. The climate is cool and moist in the winter and warm and dry in the summer. Average annual precipitation ranges from 14 to 18 inches. Average annual temperature ranges from 46 to 48 degrees F. Frost-free period is 100 to 120 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Open a Dangulch spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Dangulch silt loam, 25 to 50 percent slopes, map unit 3014 in Ada County, Idaho.
- Official Series Description: Dangulch(revised 07/2012), established.
- Taxonomic class: Fine, smectitic, mesic Calcic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.