Curlew soil
Wild-clay potential
Weak indication
Weak indication: no layer of Curlew shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Curlew soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Curlew-Riverrun complex, 0 to 2 percent slopes (Missoula County Area, Montana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 2% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 31 in (78 cm)).
- Note Typically starts about 29 in (74 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 45% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Organic top layerOe An organic top layer about 0 to 3 in down, not a clay body. Weak indication
- TopsoilA A silt loam layer about 3 to 15 in down: about 17% clay, moderate plasticity when wet, black when moist. Weak indication
- Sandy layerC1 A gravelly sandy loam layer about 15 to 29 in down: about 12% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerC2best layer A very gravelly sand layer about 29 to 60 in down: about 2% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (C2), 29 to 60 in down in the typical profile: dark grayish brown (2.5Y 4/2), light brownish gray (2.5Y 6/2) dry; loose, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: very poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Montana, in these survey areas: Missoula County Area, Montana.
By state: wild clay in Montana.
USDA, distribution and extent: Curlew soils are of small extent in mountain valleys of western Montana. MLRA 44A.
USDA, geographic setting: Landform - flood plains and drainageways
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Crow: Strong lead
- Grassvalley: Strong lead
- Half Moon: Promising
- Bignell: Possible
- Burnt Fork: Possible
- Greenough: Possible
- Minesinger: Possible
- Alberton: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 65%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Curlew-Riverrun complex, 0 to 2 percent slopes, map unit 146A in Missoula County Area, Montana.
- Official Series Description: Curlew(revised 07/2013), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, frigid Typic Endoaquolls
- Rated with rule version 2026-09-28.1; the method is on the About page.