Cranegulch soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 33 to 50 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Cranegulch soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Cranegulch spot on the map
Rated from the USDA soil survey record for Cranegulch loam, 2 to 5 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 37% clay in the fine-earth portion.
- Note USDA labels this a "Bt4" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (26): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 17 in (44 cm)).
- Note Typically starts about 33 in (83 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- TopsoilA1 A loam layer about 0 to 3 in down: about 16% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- TopsoilA2 A loam layer about 3 to 11 in down: about 18% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Clay subsoilBt1 A sandy clay loam layer about 11 to 14 in down: about 30% clay, high plasticity when wet, yellowish brown when moist. Possible
- Clay subsoilBt2 A sandy clay layer about 14 to 22 in down: about 36% clay, high plasticity when wet, yellowish brown when moist. Strong lead
- Clay subsoilBt3 A clay layer about 22 to 33 in down: about 45% clay, high plasticity when wet, yellowish brown when moist. Strong lead
- Clay subsoilBt4best layer A sandy clay layer about 33 to 50 in down: about 37% clay, high plasticity when wet, light yellowish brown when moist. Strong lead
- Clay subsoilBt5 A clay loam layer about 50 to 60 in down: about 33% clay, high plasticity when wet, light yellowish brown when moist. Possible
What it looks like raw
The clay subsoil (Bt4), 33 to 50 in down in the typical profile: light yellowish brown (10YR 6/4), dark yellowish brown (10YR 4/4) moist; very hard, firm, very sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: loamy lacustrine deposits.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: West-central Idaho. MLRA 10. Cranegulch soils are of small extent.
USDA, geographic setting: Cranegulch soils are on all hillslope positions and on structural benches and landslide deposits at elevations of 2,700 to 4,100 feet. Slopes range from 2 to 50 percent. These soils formed in loamy alluvium and colluvium from fine pyroclastic and granitic sediments deposited as basin-margin subaqueous deltas. The average annual precipitation is 13 to 17 inches. The average annual temperature is 47 to 51 degrees F. The frost-free period is 110 to 150 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Open a Cranegulch spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Cranegulch loam, 2 to 5 percent slopes, map unit 3053 in Ada County, Idaho.
- Official Series Description: Cranegulch(revised 03/2006), established.
- Taxonomic class: Fine, smectitic, mesic Typic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.