Conotton soil
Wild-clay potential
Weak indication
Weak indication: no layer of Conotton shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Conotton soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Conotton spot on the map
Rated from the USDA soil survey record for Conotton gravelly loam, 0 to 3 percent slopes (Carbon County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 19% clay. It may need settling or refining to become a clay body.
- Lowers the potential Low engineering plasticity index (3): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 14 in (36 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 21% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A gravelly loam layer about 0 to 8 in down: about 12% clay, low plasticity when wet, brown when moist. Weak indication
- Loamy layerH2best layer A gravelly sandy loam layer about 8 to 22 in down: about 19% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3 A sr to very gravelly sand to very gravelly loamy coarse sand layer about 22 to 30 in down: about 6% clay, low plasticity when wet, brown when moist. Weak indication
What it looks like raw
The loamy layer (H2), 8 to 22 in down in the typical profile: brown (7.5YR 4/4); friable. Raw colour is not fired colour.
About the soil
- Parent material: gravelly outwash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Pennsylvania, in these survey areas: Carbon County, Pennsylvania; Northampton County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Eastern Ohio, southwest Indiana, and western and east-central Pennsylvania. MLRA's 114, 115, 124, 126, 139, 140, and 147. Conotton soils are of moderate extent, about 44,000 acres.
USDA, geographic setting: Conotton soils formed in Wisconsinan age stratified sand and gravel and are on treads and risers on outwash plains and stream terraces, and on interfluves and side slopes on kames, eskers, and beach ridges. Slope ranges from 0 to 50 percent. Mean annual precipitation ranges from about 32 to 42 inches, and mean annual temperature ranges from 48 to 54 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Comly: Promising
- Holly: Promising
- Brinkerton: Promising
- Califon: Promising
- Cokesbury: Promising
- Duffield: Promising
- Shelmadine: Promising
- Washington: Promising
See it on the map
Open a Conotton spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 95%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Conotton gravelly loam, 0 to 3 percent slopes, map unit CtA in Carbon County, Pennsylvania.
- Official Series Description: Conotton(revised 01/2008), established.
- Taxonomic class: Loamy-skeletal, mixed, active, mesic Typic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.