Collister soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 42 to 58 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Collister soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Collister spot on the map
Rated from the USDA soil survey record for Collister-Flofeather complex, 1 to 3 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (20): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 16 in (40 cm)).
- Note Typically starts about 42 in (107 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- TopsoilAp1 A loam layer about 0 to 4 in down: about 22% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- TopsoilAp2 A loam layer about 4 to 10 in down: about 22% clay, moderate plasticity when wet, dark grayish brown when moist. Possible
- TopsoilA1 A loam layer about 10 to 19 in down: about 23% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- TopsoilA2 A loam layer about 19 to 23 in down: about 23% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Loamy layerBw1 A clay loam layer about 23 to 28 in down: about 30% clay, high plasticity when wet, grayish brown when moist. Possible
- Loamy layerBw2 A silty clay loam layer about 28 to 36 in down: about 30% clay, high plasticity when wet, dark grayish brown when moist. Promising
- Loamy layerBw3 A silt loam layer about 36 to 42 in down: about 26% clay, moderate plasticity when wet, dark grayish brown when moist. Possible
- Loamy layerBw4best layer A sandy clay loam layer about 42 to 58 in down: about 28% clay, high plasticity when wet, dark gray when moist. Promising
- Sandy layerC A sandy loam layer about 58 to 66 in down: about 17% clay, moderate plasticity when wet, brown when moist. Weak indication
What it looks like raw
The loamy layer (Bw4), 42 to 58 in down in the typical profile: dark gray (10YR 4/1), black (10YR 2/1) moist; hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: loamy alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern and west-central, Idaho.
USDA, geographic setting: Collister soils are on upper flood-plain steps at elevations of 2,700 to 3,750 feet. Slopes range from 1 to 3 percent. These soils formed in alluvium from mixed sediments (Tertiary) and igneous rocks. The average annual precipitation is 12 to 16 inches. The average annual temperature is 49 to 51 degrees F. The frost-free period is 130 to 150 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Open a Collister spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 65%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Collister-Flofeather complex, 1 to 3 percent slopes, map unit 1040 in Ada County, Idaho.
- Official Series Description: Collister(revised 03/2006), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Cumulic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.