Cloudyway soil
Wild-clay potential
Weak indication
Weak indication: no layer of Cloudyway shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Cloudyway soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Cloudyway spot on the map
Rated from the USDA soil survey record for Cloudyway fine gravelly sandy loam, 4 to 15 percent slopes (Boise County Area, Idaho, Western Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 7% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 19 in (48 cm)).
- Note Typically starts about 24 in (61 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 30% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Organic top layerOi An organic top layer about 0 to 1 in down, not a clay body. Weak indication
- TopsoilA1 A fine gravelly sandy loam layer about 1 to 4 in down: about 10% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- TopsoilA2 A fine gravelly sandy loam layer about 4 to 9 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
- TopsoilA3 A gravelly sandy loam layer about 9 to 18 in down: about 11% clay, low plasticity when wet, grayish brown when moist. Weak indication
- TopsoilAC A gravelly sandy loam layer about 18 to 24 in down: about 9% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerC1best layer A gravelly sandy loam layer about 24 to 43 in down: about 7% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerC2 A gravelly loamy sand layer about 43 to 60 in down: about 5% clay, low plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The sandy layer (C1), 24 to 43 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; loose, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: coarse-loamy alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Boise County Area, Idaho, Western Part.
By state: wild clay in Idaho.
USDA, distribution and extent: West-central Idaho. MLRA 43 and 44. Cloudyway soils are of small extent.
USDA, geographic setting: Cloudyway soils are moderately to strongly sloping on alluvial fans at elevations of 2,750 to 3,650 feet. These soils formed in alluvium from granitic rocks. Slopes range from 4 to 15 percent. The average annual precipitation is 20 to 26 inches. The average annual temperature is 45 to 48 degrees F. The frost-free period is 90 to 120 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aradaran: Strong lead
- Hann: Strong lead
- McDesh: Strong lead
- Shafer: Strong lead
- Hellake: Promising
- Hillcreek: Promising
- Middlefork: Promising
- Brownlee: Possible
See it on the map
Open a Cloudyway spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Cloudyway fine gravelly sandy loam, 4 to 15 percent slopes, map unit 413 in Boise County Area, Idaho, Western Part.
- Official Series Description: Cloudyway(revised 03/2006), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Cumulic Ultic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.