Cathcart soil
Wild-clay potential
Weak indication
Weak indication: no layer of Cathcart shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Cathcart soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Cathcart spot on the map
Rated from the USDA soil survey record for Cathcart gravelly silt loam, 0 to 15 percent slopes (Jefferson County Area, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 21 in (53 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Note Few rock fragments (about 13% by volume).
Layer by layer
- Sandy layerH1 A gravelly silt loam layer about 0 to 9 in down: about 15% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- Sandy layerH2best layer A gravelly loam layer about 9 to 30 in down: about 10% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerH3 A very gravelly loam layer about 30 to 38 in down: about 10% clay, low plasticity when wet, dark brown when moist. Weak indication
- BedrockH4 Weathered bedrock about 38 to 42 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H2), 9 to 30 in down in the typical profile: yellowish brown (10YR 5/4), very pale brown (10YR 7/4) dry; slightly hard, friable, slightly sticky, slightly plastic and weakly smeary. Raw colour is not fired colour.
About the soil
- Parent material: colluvium ande residuum from sandstone and shale.
- USDA family particle-size class: ashy.
- Drainage: well drained.
- Paralithic bedrock typically about 38 in (96 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Washington, in these survey areas: Jefferson County Area, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: Western Washington; MLRA 2. The series is moderately extensive.
USDA, geographic setting: Cathcart soils are on uplands at elevations of 50 to 1,400 feet. Slopes range from 2 to 65 percent. These soils formed in glacial drift, volcanic ash, sandstone, and siltstone. Cathcart soils are in a humid climate that has cool dry summers and mild wet winters. Mean annual precipitation ranges from 30 to 60 inches, most of which falls between October and April. The mean January temperature is 37 degrees F; mean July temperature is 63 degrees F; and mean annual temperature is 49oF. The frost-free season is 160 to 200 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Quilcene: Strong lead
- Wapato: Promising
- Kitsap: Possible
- Lummi: Possible
- Ahl: Weak indication
- Alderwood: Weak indication
- Beausite: Weak indication
- Belfast: Weak indication
See it on the map
Open a Cathcart spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Cathcart gravelly silt loam, 0 to 15 percent slopes, map unit ClC in Jefferson County Area, Washington.
- Official Series Description: Cathcart(revised 02/2001), established.
- Taxonomic class: Medial, mixed, mesic Typic Haploxerands
- Rated with rule version 2026-09-28.1; the method is on the About page.