Cassolary soil
Wild-clay potential
Weak indication
Weak indication: no layer of Cassolary shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Cassolary soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Cassolary spot on the map
Rated from the USDA soil survey record for Cassolary sandy loam, 0 to 15 percent slopes (Jefferson County Area, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 15% clay.
- Note Moderate engineering plasticity index (12.5).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 26 in (66 cm)).
- Note Typically starts within about 23 in (58 cm) of the surface.
- Note Few rock fragments (about 6% by volume).
Layer by layer
- Sandy layerH1 A sandy loam layer about 0 to 3 in down: about 10% clay, low plasticity when wet, dark reddish brown when moist. Weak indication
- Sandy layerH2 A sandy loam layer about 3 to 23 in down: about 10% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerH3best layer A stratified fine sandy loam to silty clay loam layer about 23 to 49 in down: about 15% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH4 A sand layer about 49 to 60 in down: about 1% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (H3), 23 to 49 in down in the typical profile: grayish brown (2.5Y 5/2), light gray (2.5Y 7/2) dry; hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: glacial drift and/or marine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 8 map units in Washington, in these survey areas: Jefferson County Area, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: Northwestern Washington. This series is moderately extensive.
USDA, geographic setting: Cassolary soils are on uplands at elevations of 50 to 500 feet. Slopes are 0 to 50 percent. These soils formed in reworked glacial drift and marine sediments. The soils are in a mild marine climate characterized by cool, dry summers and cool, moist winters. Average annual precipitation is 16 to 30 inches. Average January temperature is about 39 degrees F., average July temperature is about 60 degrees F., and the mean annual temperature is about 50 degrees F. Frost-free season is 160 to 200 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Quilcene: Strong lead
- Wapato: Promising
- Kitsap: Possible
- Lummi: Possible
- Ahl: Weak indication
- Alderwood: Weak indication
- Beausite: Weak indication
- Belfast: Weak indication
See it on the map
Open a Cassolary spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Cassolary sandy loam, 0 to 15 percent slopes, map unit CfC in Jefferson County Area, Washington.
- Official Series Description: Cassolary(revised 01/2000), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Vitrandic Haploxerepts
- Rated with rule version 2026-09-28.1; the method is on the About page.