Canburn soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 21 to 48 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Canburn soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Canburn spot on the map
Rated from the USDA soil survey record for Canburn silt loam (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (12.5).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 27 in (69 cm)).
- Note Typically starts within about 21 in (53 cm) of the surface.
- Note Few rock fragments (about 11% by volume).
- Note USDA reports about 9% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA11 A silt loam layer about 0 to 8 in down: about 23% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- TopsoilA12 A silt loam layer about 8 to 21 in down: about 23% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Loamy layerCbest layer A silt loam layer about 21 to 48 in down: about 23% clay, moderate plasticity when wet, light brownish gray when moist. Possible
- TopsoilA1b A silt loam layer about 48 to 60 in down: about 23% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The loamy layer (C), 21 to 48 in down in the typical profile: light brownish gray (10YR 6/2), very dark grayish brown (10YR 3/2) moist; hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from limestone, sandstone and quartzite.
- USDA family particle-size class: fine-loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County.
By state: wild clay in Utah.
USDA, distribution and extent: Central and northern Utah and northeastern Arizona, northwestern New Mexico, Montana and Wyoming. The series is moderately extensive. MLRA 28A, 34, 39A, 47, 49, and 58A.
USDA, geographic setting: Parent material: alluvium derived from mixed sources
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ant Flat: Strong lead
- Bertag: Strong lead
- Broadhead: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Hawkins: Strong lead
- Herd: Strong lead
- Isbell: Strong lead
See it on the map
Open a Canburn spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Canburn silt loam, map unit Cb in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Canburn(revised 04/2011), established.
- Taxonomic class: Fine-loamy, mixed, superactive, calcareous, frigid Cumulic Endoaquolls
- Rated with rule version 2026-09-28.1; the method is on the About page.