Cabbart soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 2 to 13 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Cabbart soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Cabbart spot on the map
Rated from the USDA soil survey record for Cabbart loam, 25 to 40 percent slopes (Butte County, South Dakota) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 26% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (12.5).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Moderate thickness (about 11 in (28 cm)).
- Note Typically starts within about 2 in (5 cm) of the surface.
- Note Few rock fragments (about 6% by volume).
- Note USDA reports about 18% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Loamy layerH1 A loam layer about 0 to 2 in down: about 24% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Loamy layerH2best layer A loam layer about 2 to 13 in down: about 26% clay, moderate plasticity when wet, pale yellow when moist. Possible
- BedrockCr Weathered bedrock about 13 to 60 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 2 to 13 in down in the typical profile: pale yellow (2.5Y 7/4), light yellowish brown (2.5Y 6/4) moist; hard, very friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from sedimentary rock.
- USDA family particle-size class: loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 15 in (38 cm) down.
Where it is mapped
Seen on the map as the most common soil in 4 map units in South Dakota, in these survey areas: Butte County, South Dakota; Meade County, South Dakota, Northern Part.
By state: wild clay in South Dakota.
USDA, distribution and extent: Eastern Montana and western North Dakota. The series is extensive.
USDA, geographic setting: Landform - hills; escarpments; ridges; sedimentary plains; strath terraces. Elevations - 1,900 to 5,400 feet. Allow elevation to range to 6500 feet in MLRA 44. Slopes- 2 to 75 percent. Parent material - materials derived from semiconsolidated loamy sedimentary beds of Cretaceous and/or Tertiary age. Climate - long, cold winters; moist springs; warm summers. Mean annual precipitation - 10 to 16 inches of which approximately three-quarters falls during the growing season. Mean annual air temperature - 39 to 45 degrees F. Allow MAAT to range to 38 degrees F in MLRA 44. Frost-free period - 95 to 135 days. Allow frost-free period to range to 90 days in MLRA 44.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Absher: Strong lead
- Hisle: Strong lead
- Kyle: Strong lead
- Pierre: Strong lead
- Stetter: Strong lead
- Swanboy: Strong lead
- Winler: Strong lead
- Abor: Strong lead
See it on the map
Open a Cabbart spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Cabbart loam, 25 to 40 percent slopes, map unit CaF in Butte County, South Dakota.
- Official Series Description: Cabbart(revised 04/2002), established.
- Taxonomic class: Loamy, mixed, superactive, calcareous, frigid, shallow Aridic Ustorthents
- Rated with rule version 2026-09-28.1; the method is on the About page.