Buckingham soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 30 to 44 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Buckingham soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Buckingham spot on the map
Rated from the USDA soil survey record for Buckingham silt loam, 3 to 8 percent slopes (Bucks County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note USDA labels this a "Btx1" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (10).
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 14 in (36 cm)).
- Note Typically starts about 30 in (76 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 14% by volume).
Layer by layer
- TopsoilA A silt loam layer about 0 to 7 in down: about 18% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Clay subsoilBt A silt loam layer about 7 to 30 in down: about 25% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay subsoilBtx1best layer A silty clay loam layer about 30 to 44 in down: about 28% clay, moderate plasticity when wet, pinkish gray when moist. Possible
- Clay subsoilBtx2 A gravelly silt loam layer about 44 to 70 in down: about 21% clay, moderate plasticity when wet, pinkish gray when moist. Weak indication
What it looks like raw
The clay subsoil (Btx1), 30 to 44 in down in the typical profile: pinkish gray (7.5YR 6/2), and strong brown (7.5YR 5/6); silt loam; firm, nonsticky, nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: fine-loamy colluvium and old alluvium derived from shale and siltstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: somewhat poorly drained.
- Lithic bedrock typically about 89 in (227 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Pennsylvania, in these survey areas: Bucks County, Pennsylvania; Montgomery County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Pennsylvania. The series is of moderate extent.
USDA, geographic setting: Buckingham soils are at heads of drains and along drainageways in the Northern piedmont Province. The soils are on concave toe slopes and in depressions. They are formed in colluvium and alluvium derived from weathered gray and red metamorphic shale, siltstone, and sandstone materials. Slope ranges from 0 to 8 percent. Mean annual precipitation is 42 to 45 inches. The mean annual air temperature is 45 to 63 degrees F. The frost-free days range from 155 to 190.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Watchung: Strong lead
- Bowmansville: Promising
- Croton: Promising
- Hatboro: Promising
- Mount Lucas: Promising
- Raritan: Promising
- Readington: Promising
- Rowland: Promising
See it on the map
Open a Buckingham spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 88%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Buckingham silt loam, 3 to 8 percent slopes, map unit BwB in Bucks County, Pennsylvania.
- Official Series Description: Buckingham(revised 10/2008), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Aeric Fragiaqualfs
- Rated with rule version 2026-09-28.1; the method is on the About page.