Broad Canyon soil
Wild-clay potential
Weak indication
Weak indication: no layer of Broad Canyon shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Broad Canyon soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Broad Canyon spot on the map
Rated from the USDA soil survey record for Broad Canyon stony loam, 30 to 70 percent (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 13% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 30 in (76 cm)).
- Note Typically starts about 30 in (76 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 65% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA11 A very stony loam layer about 0 to 4 in down: about 23% clay, moderate plasticity when wet, very dark brown when moist. Weak indication
- TopsoilA12, A13 An extremely cobbly loam layer about 4 to 15 in down: about 23% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- Loamy layerB2 An extremely cobbly loam layer about 15 to 30 in down: about 23% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Sandy layerCbest layer An extremely cobbly sandy loam layer about 30 to 60 in down: about 13% clay, low plasticity when wet, reddish brown when moist. Weak indication
What it looks like raw
The sandy layer (C), 30 to 60 in down in the typical profile: reddish brown (5YR 4/3), pink (5YR 7/3) dry; loose. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from sandstone, gneiss, schist, and argillite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County.
By state: wild clay in Utah.
USDA, distribution and extent: Northeastern Utah, western part of Uinta Mountains, and south central Idaho. These soils are not extensive.
USDA, geographic setting: These soils are on lateral moraines or glaciated mountainsides at elevations of 1,980 or 2,960 meters. In the southern part of Idaho, these soils formed in granite or limestone colluvium and occur on north-facing mountain slopes down to elevations of 1,520 meters. Slopes range from 20 to 70 percent. These soils formed in materials weathered mainly from quartzite, sandstone, limestone and some shale. Average annual temperature is 0.6 to 7.2 degrees C and the average summer temperature is 10.0 to 14.4 degrees C. The frost-free period is 30 to 60 days. Average annual precipitation is 635 to 1250 mm. Soil moisture regime is Udic.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ant Flat: Strong lead
- Bertag: Strong lead
- Broadhead: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Hawkins: Strong lead
- Herd: Strong lead
- Isbell: Strong lead
See it on the map
Open a Broad Canyon spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Broad Canyon stony loam, 30 to 70 percent, map unit BdG in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Broad Canyon(revised 01/2018), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive Typic Haplocryolls
- Rated with rule version 2026-09-28.1; the method is on the About page.