Brecknock soil
Wild-clay potential
Weak indication
Weak indication: no layer of Brecknock shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Brecknock soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Brecknock spot on the map
Rated from the USDA soil survey record for Brecknock channery silt loam, 8 to 25 percent slopes, extremely stony (Montgomery County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 25% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (17).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 22 in (56 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 29% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A channery silt loam layer about 0 to 10 in down: about 15% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- Loamy layerH2best layer A channery silt loam layer about 10 to 32 in down: about 25% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerH3 A very channery silt loam layer about 32 to 41 in down: about 25% clay, moderate plasticity when wet, very dark gray when moist. Weak indication
- BedrockH4 Bedrock about 41 to 51 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 10 to 32 in down in the typical profile: dark grayish brown (2.5Y 4/2); friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from porcellanite and/or red metamorphosed residuum weathered from sandstone and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 41 in (104 cm) down.
Where it is mapped
Seen on the map as the most common soil in 25 map units in Pennsylvania, in these survey areas: Berks County, Pennsylvania; Bucks County, Pennsylvania; Chester County, Pennsylvania; Lancaster County, Pennsylvania; Lebanon County, Pennsylvania; Montgomery County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Pennsylvania, New Jersey, and Virginia. The series is of small extent.
USDA, geographic setting: Brecknock soils are on nearly level to very steep convex slopes of upland hills and low ridges. They formed in residuum weathered from metamorphosed red shale and sandstone (porcelanite). Climate is humid and temperate with mean annual temperature of 50 to 55 degrees F.; mean annual precipitation ranges from 40 to 48 inches; and the growing season ranges from 165 to 200 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Watchung: Strong lead
- Hagerstown: Strong lead
- Bowmansville: Promising
- Mount Lucas: Promising
- Readington: Promising
- Rowland: Promising
- Duffield: Promising
- Towhee: Promising
See it on the map
Open a Brecknock spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 94%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Brecknock channery silt loam, 8 to 25 percent slopes, extremely stony, map unit BvD in Montgomery County, Pennsylvania.
- Official Series Description: Brecknock(revised 02/2008), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Ultic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.