Bissell soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 25 to 41 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bissell soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Bissell spot on the map
Rated from the USDA soil survey record for Bissell loam, 0 to 2 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 27% clay in the fine-earth portion.
- Note USDA labels this a "Bt3" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (19).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 16 in (40 cm)).
- Note Typically starts about 25 in (64 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- TopsoilAp A loam layer about 0 to 8 in down: about 22% clay, moderate plasticity when wet, gray when moist. Possible
- Clay subsoilBt1 A clay loam layer about 8 to 18 in down: about 28% clay, high plasticity when wet, gray when moist. Promising
- Clay subsoilBt2 A clay loam layer about 18 to 25 in down: about 30% clay, high plasticity when wet, light brownish gray when moist. Promising
- Clay subsoilBt3best layer A clay loam layer about 25 to 41 in down: about 27% clay, moderate plasticity when wet, light brownish gray when moist. Promising
- Loamy layerC1 A loam layer about 41 to 60 in down: about 18% clay, moderate plasticity when wet, light brownish gray when moist. Possible
- Sandy layerC2 A sandy loam layer about 60 to 66 in down: about 10% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt3), 25 to 41 in down in the typical profile: light brownish gray (2.5Y 6/2), dark grayish brown (2.5Y 4/2) moist; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: loamy alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern Idaho. MLRA 11. The Bissell soils are not extensive.
USDA, geographic setting: Bissell soils are nearly level to moderately sloping on fan remnants, relict alluvial fans, and stream terraces at elevations of 2,100 to 3,500 feet. Slopes range from 0 to 8 percent. The soils formed in alluvium with significant amounts of mica and feldspar dominantly from granitic rocks mixed with minor amounts of alluvium from volcaniclastic sediments and other igneous rocks. The average annual precipitation is 10 to 15 inches. The average annual temperature is 48 to 52 degrees F. The frost-free period is 140 to 155 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Open a Bissell spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bissell loam, 0 to 2 percent slopes, map unit 1008 in Ada County, Idaho.
- Official Series Description: Bissell(revised 03/2006), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Aridic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.