Bickmore soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 10 to 22 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bickmore soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Bickmore spot on the map
Rated from the USDA soil survey record for Bickmore loam, 50 to 70 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 31% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (12.5).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 12 in (31 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 30% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilA1 A loam layer about 0 to 10 in down: about 23% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Loamy layerB2tbest layer A gravelly silty clay loam layer about 10 to 22 in down: about 31% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerCca A very gravelly loam layer about 22 to 39 in down: about 23% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- BedrockR Unweathered bedrock about 39 to 49 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (B2t), 10 to 22 in down in the typical profile: brown (10YR 4/3), dark brown (10YR 3/3) moist; slightly hard, friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from limestone and/or residuum weathered from limestone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 39 in (99 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Utah, in these survey areas: Box Elder County, Utah, Eastern Part; Cache Valley Area, Parts of Cache and Box Elder Counties, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Northern Utah. This series is inextensive.
USDA, geographic setting: Bickmore soils occur on very steep north and east facing mountain slopes at elevations of 6,000 to 8,000 feet. Slope ranges from 5 to 70 percent. These soils formed in colluvium and residuum from limestone. The average annual precipitation ranges from 22 to 35 inches. The mean annual temperature is 38 degrees to 42 degrees F. The frost-free period is 80 to 100 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Collett: Strong lead
- Eimarsh: Strong lead
- Goring: Strong lead
- Lasil: Strong lead
- Manila: Strong lead
- Obray: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
See it on the map
Open a Bickmore spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 95%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bickmore loam, 50 to 70 percent slopes, map unit BCG in Box Elder County, Utah, Eastern Part.
- Official Series Description: Bickmore(revised 12/2003), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive Pachic Argicryolls
- Rated with rule version 2026-09-28.1; the method is on the About page.