Bangor soil
Wild-clay potential
Weak indication
Weak indication: no layer of Bangor shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bangor soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Bangor silt loam, 3 to 8 percent slopes (Somerset County, Maine, Southern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 6% clay.
- Lowers the potential Low engineering plasticity index (2): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 42 in (107 cm)).
- Note Typically starts within about 23 in (58 cm) of the surface.
- Note Few rock fragments (about 14% by volume).
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 8 in down: about 7% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerH2 A silt loam layer about 8 to 23 in down: about 6% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerH3best layer A silt loam layer about 23 to 65 in down: about 6% clay, low plasticity when wet, olive when moist. Weak indication
What it looks like raw
The sandy layer (H3), 23 to 65 in down in the typical profile: olive (5Y 5/4); firm. Raw colour is not fired colour.
About the soil
- Parent material: coarse-loamy supraglacial meltout till derived from phyllite and/or coarse-loamy supraglacial meltout till derived from slate.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Maine, in these survey areas: Somerset County, Maine, Southern Part.
By state: wild clay in Maine.
USDA, distribution and extent: Central and northern Maine, New Hampshire and Vermont; MLRA's 143 and 144B. The series is of large extent.
USDA, geographic setting: Bangor soils are on till plains and ridges. Slope ranges from 0 to 25 percent. The soils formed in glacial till derived mainly from slate, shale and phyllite with small amounts of granite, fine grained quartzite, and sandstone. The mean annual air temperature ranges from 41 to 46 degrees F, and the mean annual precipitation ranges from 34 to 46 inches. The frost-free season ranges from 100 to 150 days. Elevation ranges from 10 to 1000 feet above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Biddeford: Strong lead
- Buxton: Strong lead
- Lamoine: Strong lead
- Melrose: Strong lead
- Scantic: Strong lead
- Suffield: Strong lead
- Adams: Weak indication
- Berkshire: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 87%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bangor silt loam, 3 to 8 percent slopes, map unit BaB in Somerset County, Maine, Southern Part.
- Official Series Description: Bangor(revised 02/2000), established.
- Taxonomic class: Coarse-loamy, isotic, frigid Typic Haplorthods
- Rated with rule version 2026-09-28.1; the method is on the About page.