Banbury soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 6 to 12 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Banbury soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Banbury spot on the map
Rated from the USDA soil survey record for Banbury-McPan-Rock outcrop complex, 2 to 15 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 25% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (17).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Moderate thickness (about 6 in (15 cm)).
- Note Typically starts within about 6 in (15 cm) of the surface.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- TopsoilA1 A cobbly silt loam layer about 0 to 2 in down: about 17% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- TopsoilA2 A silt loam layer about 2 to 6 in down: about 19% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay subsoilBtbest layer A silt loam layer about 6 to 12 in down: about 25% clay, moderate plasticity when wet, brown when moist. Possible
- Bedrock2R Bedrock about 12 to 16 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Bt), 6 to 12 in down in the typical profile: brown (10YR 5/3), dark yellowish brown (10YR 3/4) moist; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: loess and/or weathered volcanic ash and/or colluvium derived from basalt over basalt.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy.
- Drainage: well drained.
- Lithic bedrock typically about 12 in (30 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: South-central and southwestern Idaho; MLRA 11. Series is of moderate extent.
USDA, geographic setting: Banbury soils are on hills, terraces, lava flow lobes, pressure ridges and tumuli on shield volcanoes and lava plains. Slopes range from 2 to 25 percent. The soils formed in old alluvium from loess and weathered volcanic ash mixed with colluvium from basalt. Elevations are 3,000 to 4,500 feet. The average annual precipitation ranges from 8 to 11 inches. Average annual temperature is 49 degrees to 54 degrees F. The frost free season is 100 to 150 days. - terms used throughout MLRA 11 to identify the setting of this soil are quite varied although all equate to the same landscape. There will be further investigation from an MLRA project level as to the accepted terms for use. The...
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Open a Banbury spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 40%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Banbury-McPan-Rock outcrop complex, 2 to 15 percent slopes, map unit 4103 in Ada County, Idaho.
- Official Series Description: Banbury(revised 08/2000), established.
- Taxonomic class: Loamy, mixed, superactive, mesic Lithic Xeric Haplargids
- Rated with rule version 2026-09-28.1; the method is on the About page.