Ballentine soil
Wild-clay potential
Weak indication
Weak indication: no layer of Ballentine shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ballentine soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Ballentine spot on the map
Rated from the USDA soil survey record for Ballentine-Eagle complex, 0 to 1 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (2): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 35 in (89 cm)).
- Note Typically starts about 35 in (89 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 55% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA1 A fine sandy loam layer about 0 to 2 in down: about 11% clay, low plasticity when wet, grayish brown when moist. Weak indication
- TopsoilA2 A fine sandy loam layer about 2 to 14 in down: about 11% clay, low plasticity when wet, brown when moist. Weak indication
- TopsoilAC A fine sandy loam layer about 14 to 22 in down: about 8% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerC1 A fine sandy loam layer about 22 to 35 in down: about 7% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layer2C2best layer A stratified extremely gravelly coarse sand to very gravelly loamy sand layer about 35 to 70 in down: about 5% clay, low plasticity when wet. Weak indication
What it looks like raw
The sandy layer (2C2), 35 to 70 in down in the typical profile: multi-colored very gravelly sand; loose, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: coarse-loamy alluvium over sandy and gravelly alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy over sandy or sandy-skeletal.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern Idaho. MLRA 11. Ballentine soils are of small extent.
USDA, geographic setting: The Ballentine soils are on stream terraces at elevations of 748 to 869 meters. Slopes range from 0 to 1 percent. These soils formed in recent alluvium from granitic rocks with minor influence of other igneous materials. The average annual precipitation is 254 to 330 mm. The average annual temperature is 10 to 11 degrees C. The frost-free period is 145 to 155 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Open a Ballentine spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 45%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ballentine-Eagle complex, 0 to 1 percent slopes, map unit 1002 in Ada County, Idaho.
- Official Series Description: Ballentine(revised 07/2012), established.
- Taxonomic class: Coarse-loamy over sandy or sandy-skeletal, mixed, superactive, mesic Torrifluventic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.