Agassiz soil
Wild-clay potential
Weak indication
Weak indication: no layer of Agassiz shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Agassiz soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Agassiz spot on the map
Rated from the USDA soil survey record for Agassiz-Rock outcrop complex, 40 to 70 percent slopes (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (12.5).
- Note The official series description calls the wet soil slightly plastic.
- Note Moderate thickness (about 8 in (20 cm)).
- Note Typically starts within about 0 in (0 cm) of the surface.
- Lowers the potential High rock content (about 47% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
- Lowers the potential Surface layer with about 3% organic matter; roots and organics complicate use.
Layer by layer
- TopsoilA11, A12best layer A very cobbly silt loam layer about 0 to 8 in down: about 23% clay, moderate plasticity when wet, brown when moist. Weak indication
- Loamy layerB2 An extremely cobbly silt loam layer about 8 to 14 in down: about 23% clay, moderate plasticity when wet, brown when moist. Weak indication
- BedrockR Unweathered bedrock about 14 to 18 in down: no clay layer to dig. Weak indication
What it looks like raw
The topsoil (A11, A12), 0 to 8 in down in the typical profile: brown (7.5YR 5/3), dark brown (10YR 3/3) moist; soft, very friable, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium over residuum derived from limestone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: somewhat excessively drained.
- Lithic bedrock typically about 14 in (36 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County; Summit Area, Utah, Parts of Summit, Salt Lake and Wasatch Counties.
By state: wild clay in Utah.
USDA, distribution and extent: Mountain areas of northern and central Utah. This series is moderately extensive. MLRA 28A, 47.
USDA, geographic setting: Agassiz soils are at elevations of 5,200 to 8,700 feet. They are on strongly sloping and very steep, dominantly south and west-facing mountain slopes with gradients of 4 to 70 percent. The soils formed in colluvium over fractured, weathering limestone. The climate is moist subhumid or humid, the average annual precipitation is about 16 to 22 inches. The mean annual temperature is 31 to 47 degrees F., and the average summer temperature is 59 to 64 degrees F. Freeze-free period is 30 to 100 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Manila: Strong lead
- Ant Flat: Strong lead
- Bertag: Strong lead
- Broadhead: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Hawkins: Strong lead
- Herd: Strong lead
See it on the map
Open a Agassiz spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 70%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Agassiz-Rock outcrop complex, 40 to 70 percent slopes, map unit AaG in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Agassiz(revised 04/2009), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, frigid Lithic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.