Zumbro soil
Wild-clay potential
Weak indication
Weak indication: no layer of Zumbro shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Zumbro soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Zumbro sandy loam, 1 to 6 percent slopes, occasionally flooded (Pike County, Illinois) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 2% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 38 in (96 cm)).
- Note Typically starts about 42 in (107 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 9% by volume).
Layer by layer
- Sandy layerH1 A sandy loam layer about 0 to 11 in down: about 12% clay, moderate plasticity when wet, very dark brown when moist. Weak indication
- Sandy layerH2 A loamy sand layer about 11 to 33 in down: about 6% clay, low plasticity when wet, very dark brown when moist. Weak indication
- Sandy layerH3 A sand layer about 33 to 42 in down: about 5% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- Sandy layerH4best layer A sand layer about 42 to 80 in down: about 2% clay, low plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (H4), 42 to 80 in down in the typical profile: grayish brown (10YR 5/2); loose. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Illinois, in these survey areas: Pike County, Illinois.
By state: wild clay in Illinois.
USDA, distribution and extent: Southeastern Minnesota and Illinois and possibly southwestern Wisconsin and northeastern Iowa. Moderately extensive (about 10,000 acres in Minnesota).
USDA, geographic setting: The Zumbro soils primarily are on high bottoms or low terraces, but in a few places they are on alluvial fans. They have plane or slightly concave slopes with gradient of less than 2 percent. The Zumbro soils formed in sandy post glacial alluvium that is several feet thick. Mean annual temperature is 45 to 50 degrees F, and mean annual precipitation is 27 to 34 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Darwin: Strong lead
- Elco: Strong lead
- Ipava: Strong lead
- Keswick: Strong lead
- Titus: Strong lead
- Ambraw: Promising
- Baylis: Promising
- Beaucoup: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Zumbro sandy loam, 1 to 6 percent slopes, occasionally flooded, map unit 8349B in Pike County, Illinois.
- Official Series Description: Zumbro, established.
- Taxonomic class: Sandy, mixed, mesic Entic Hapludolls
- Rated with rule version 2026-09-28.1; the method is on the About page.