Ipava soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 18 to 31 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ipava soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Ipava silt loam, 0 to 2 percent slopes (Pike County, Illinois) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 37% clay in the fine-earth portion.
- Note USDA labels this a "Btg1" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (26): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 13 in (33 cm)).
- Note Typically starts within about 18 in (46 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 6.5%): often very plastic, and prone to cracking as it dries.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 10 in down: about 25% clay, moderate plasticity when wet, black when moist. Weak indication
- TopsoilA A silty clay loam layer about 10 to 18 in down: about 33% clay, high plasticity when wet, very dark grayish brown when moist. Promising
- Clay subsoilBtg1best layer A silty clay loam layer about 18 to 31 in down: about 37% clay, high plasticity when wet, dark grayish brown when moist. Strong lead
- Clay subsoilBtg2 A silty clay loam layer about 31 to 50 in down: about 31% clay, high plasticity when wet, grayish brown when moist. Promising
- Loamy layerCg A silt loam layer about 50 to 60 in down: about 21% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The clay subsoil (Btg1), 18 to 31 in down in the typical profile: dark grayish brown (10YR 4/2); silty clay; firm. Raw colour is not fired colour.
About the soil
- Parent material: loess.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Illinois, in these survey areas: Pike County, Illinois.
By state: wild clay in Illinois.
USDA, distribution and extent: MLRAs 108A, 108B, 110, and 115C in Illinois and Indiana. The series is extensive. More than 785,000 acres have been correlated.
USDA, geographic setting: Ipava soils are on nearly level to gently sloping broad summits on uplands. A minor acreage has been correlated on stream terraces. Slope gradients typically are between 1 and 3 percent and range from 0 to 5 percent. Ipava soils formed in loess. Mean annual temperature ranges from 10.0 to 13.3 degrees C (50 to 56 degrees F). Mean annual precipitation ranges from 914 to 1,016 mm (36 to 40 inches). Frost-free period ranges from 160 to 190 days. Elevation is 180 to 250 meters (590 to 820 feet) above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Darwin: Strong lead
- Elco: Strong lead
- Keswick: Strong lead
- Titus: Strong lead
- Ambraw: Promising
- Baylis: Promising
- Beaucoup: Promising
- Bethalto: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ipava silt loam, 0 to 2 percent slopes, map unit 43A in Pike County, Illinois.
- Official Series Description: Ipava(revised 04/2015), established.
- Taxonomic class: Fine, smectitic, mesic Aquic Argiudolls
- Rated with rule version 2026-09-28.1; the method is on the About page.