Keswick soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 8 to 47 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Keswick soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Keswick spot on the map
Rated from the USDA soil survey record for Keswick loam, 18 to 25 percent slopes, eroded (Pike County, Illinois) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 41% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (29): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 39 in (99 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Note Few rock fragments (about 11% by volume).
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Loamy layerH1 A loam layer about 0 to 8 in down: about 24% clay, moderate plasticity when wet, grayish brown when moist. Possible
- Clay-rich layerH2best layer A silty clay layer about 8 to 47 in down: about 41% clay, high plasticity when wet, percent strong brown when moist. Strong lead
- Clay-rich layerH3 A clay loam layer about 47 to 60 in down: about 35% clay, high plasticity when wet, yellowish brown when moist. Strong lead
What it looks like raw
The clay-rich layer (H2), 8 to 47 in down in the typical profile: percent strong brown (7.5YR 5/6), percent yellowish brown (10YR 5/6); firm. Raw colour is not fired colour.
About the soil
- Parent material: paleosol formed in preIllinoian till.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Illinois, Missouri, in these survey areas: Pike County, Illinois; Pike County, Missouri.
By state: wild clay in Illinois,wild clay in Missouri.
USDA, distribution and extent: Physiographic Division--Interior Plains
USDA, geographic setting: Parent material--25 to 50 centimeters of loess or loamy sediments and in the underlying paleosol weathered from glacial till
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bremer: Strong lead
- Bucklick: Strong lead
- Carlow: Strong lead
- Chequest: Strong lead
- Crider: Strong lead
- Darwin: Strong lead
- Dupo: Strong lead
- Elco: Strong lead
See it on the map
Open a Keswick spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Keswick loam, 18 to 25 percent slopes, eroded, map unit 651E2 in Pike County, Illinois.
- Official Series Description: Keswick(revised 08/2006), established.
- Taxonomic class: Fine, smectitic, mesic Aquertic Chromic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.