Wilma soil
Wild-clay potential
Weak indication
Weak indication: no layer of Wilma shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Wilma soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Wilma stony fine sandy loam, 30 to 60 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 13 in (33 cm)).
- Note Typically starts about 24 in (61 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 39% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A stony ashy fine sandy loam layer about 0 to 4 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2 A gravelly ashy sandy loam layer about 4 to 12 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3 A very gravelly ashy fine sandy loam layer about 12 to 24 in down: about 8% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layerH4best layer A very gravelly loamy sand layer about 24 to 37 in down: about 5% clay, low plasticity when wet, brownish yellow when moist. Weak indication
- BedrockH5 Unweathered bedrock about 37 to 41 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H4), 24 to 37 in down in the typical profile: brownish yellow (10YR 6/6), dark yellowish brown (10YR 4/6) moist; slightly hard, friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium and residuum from granitic rocks with a mantle of volcanic ash.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 37 in (94 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: North Central and Northeastern Washington; MLRA 6. Series is of small extent.
USDA, geographic setting: Wilma soils are on backslopes, shoulders, ridgecrests, and spur ridges that usually have a southerly aspect of mountains. Slopes are 15 to 65 percent. Wilma soils formed in volcanic ash overlying residuum and colluvium from granitic rock with a thin mantle of ash. Elevations range from 2,400 to 5,800 feet. The climate is characterized by warm, dry summers and cool, moist winters. The average annual precipitation is about 18 to 35 inches. The mean January temperature is about 25 degrees F, the mean July temperature is about 65 degrees F, and the mean annual temperature is about 40 to 46 degrees F. The growing season at 28 degrees F is 90 to 175 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Wilma stony fine sandy loam, 30 to 60 percent slopes, map unit 365 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Wilma(revised 07/2005), established.
- Taxonomic class: Loamy-skeletal, isotic, frigid Andic Haploxerepts
- Rated with rule version 2026-09-28.1; the method is on the About page.