Wedge soil
Wild-clay potential
Weak indication
Weak indication: no layer of Wedge shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Wedge soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Wedge cindery fine sandy loam, 8 to 30 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 1% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 29 in (73 cm)).
- Note Typically starts about 31 in (79 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 36% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A paragravelly ashy sandy loam layer about 0 to 5 in down: about 8% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2 A paragravelly ashy sandy loam layer about 5 to 11 in down: about 10% clay, low plasticity when wet. Weak indication
- Sandy layerH3 A very paragravelly ashy sandy loam layer about 11 to 31 in down: about 6% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layerH4best layer A cinders layer about 31 to 60 in down: about 1% clay, low plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The sandy layer (H4), 31 to 60 in down in the typical profile: loose, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash and pumice.
- USDA family particle-size class: ashy-pumiceous.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: East slopes of Cascade Mountains in central part of Chelan County, Washington. The series is of moderate extent.
USDA, geographic setting: Wedge soils are on toe slopes and back slopes of mountains at elevations of 2,500 to 5,500 feet. Slopes are 0 to 60 percent. Wedge soils formed in volcanic ash and pumice. The climate is characterized by warm, dry summers and cold, wet winters. The average annual precipitation is 35 to 55 inches. The mean January temperature is about 21 degrees F., mean July temperature is about 60 degrees F., and the mean annual air temperature is 37 to 40 degrees F. The growing season at 28 degrees is 90 to 140 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Wedge cindery fine sandy loam, 8 to 30 percent slopes, map unit 360 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Wedge(revised 07/2003), established.
- Taxonomic class: Ashy-pumiceous, glassy Xeric Vitricryands
- Rated with rule version 2026-09-28.1; the method is on the About page.