Waxpool soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 20 to 34 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Waxpool soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Waxpool spot on the map
Rated from the USDA soil survey record for Waxpool silt loam, occasionally ponded, 0 to 2 percent slopes (Fauquier County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 50% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (36): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 14 in (35 cm)).
- Note Typically starts within about 20 in (51 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 8.9%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA A silt loam layer about 0 to 7 in down: about 15% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- Clay subsoilBtg A clay layer about 7 to 20 in down: about 50% clay, high plasticity when wet, dark yellowish brown when moist. Strong lead
- Clay subsoilBtbest layer A clay layer about 20 to 34 in down: about 50% clay, high plasticity when wet, dark yellowish brown when moist. Strong lead
- Loamy layerBC A silty clay loam layer about 34 to 38 in down: about 30% clay, high plasticity when wet, dark yellowish brown when moist. Possible
- Sandy layerC A sandy loam layer about 38 to 84 in down: about 10% clay, low plasticity when wet, brownish yellow when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 20 to 34 in down in the typical profile: dark yellowish brown (10YR 4/4); very firm, very sticky, very plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from diabase.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Virginia, in these survey areas: Fauquier County, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Northern Virginia, Maryland and Pennsylvania. The series is of moderate extent. 5,000 acres mapped in Prince William County.
USDA, geographic setting: Waxpool soils are on Northern Piedmont Plateau Uplands commonly associated with the Triassic Region. These soils are on broad upland flats and slope gradients range from 0 to 3 percent. They have developed in residuum from diabase and basalt. Mean annual precipitation ranges from 36 to 44 inches and mean annual temperature ranges from 52 to 57 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Albano: Strong lead
- Appling: Strong lead
- Cecil: Strong lead
- Clover: Strong lead
- Dulles: Strong lead
- Fletcherville: Strong lead
- Jackland: Strong lead
- Kelly: Strong lead
See it on the map
Open a Waxpool spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Waxpool silt loam, occasionally ponded, 0 to 2 percent slopes, map unit 66A in Fauquier County, Virginia.
- Official Series Description: Waxpool(revised 06/2013), established.
- Taxonomic class: Fine, smectitic, mesic Vertic Epiaqualfs
- Rated with rule version 2026-09-28.1; the method is on the About page.