Wawasee soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 8 to 38 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Wawasee soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Wawasee spot on the map
Rated from the USDA soil survey record for Wawasee fine sandy loam, 2 to 6 percent slopes (Kosciusko County, Indiana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (17.5).
- Note Thick enough to investigate (about 30 in (77 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Note Few rock fragments (about 7% by volume).
Layer by layer
- TopsoilAp A fine sandy loam layer about 0 to 8 in down: about 7% clay, low plasticity when wet. Weak indication
- Clay subsoilBtbest layer A loam layer about 8 to 38 in down: about 23% clay, moderate plasticity when wet, yellowish brown when moist. Possible
- Sandy layerC A loam layer about 38 to 79 in down: about 13% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 8 to 38 in down in the typical profile: yellowish brown (10YR 5/4); firm. Raw colour is not fired colour.
About the soil
- Parent material: coarse-loamy till.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Indiana, in these survey areas: Kosciusko County, Indiana.
By state: wild clay in Indiana.
USDA, distribution and extent: MLRAs 98 and 111C in northern Indiana. The series is of large extent.
USDA, geographic setting: Wawasee soils are on moraines and till plains of Wisconsin age. Slope ranges from 0 to 18 percent and are plan or convex. Wawasee soils formed in till. Mean annual precipitation ranges from 889 to 1016 mm (35 to 40 inches). Mean annual temperature ranges from 7.2 to 12.8 degrees C (45 to 55 degrees F.)
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Del Rey: Strong lead
- Saranac: Strong lead
- Toledo: Strong lead
- Aubbeenaubbee: Promising
- Crosier: Promising
- Metea: Promising
- Miami: Promising
- Rensselaer: Promising
See it on the map
Open a Wawasee spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Wawasee fine sandy loam, 2 to 6 percent slopes, map unit WlB in Kosciusko County, Indiana.
- Official Series Description: Wawasee(revised 11/2021), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Typic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.