Toledo soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 42 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Toledo soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Toledo silty clay (Kosciusko County, Indiana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (20): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 18 in (45 cm)).
- Note Typically starts about 42 in (107 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note USDA reports about 23% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Clay-rich layerAp A silty clay layer about 0 to 6 in down: about 42% clay, high plasticity when wet, very dark gray when moist. Promising
- Clay-rich layerA A silty clay layer about 6 to 9 in down: about 45% clay, high plasticity when wet, very dark gray when moist. Possible
- Clay-rich layerBg1 A silty clay layer about 9 to 15 in down: about 45% clay, high plasticity when wet, dark gray when moist. Strong lead
- Clay-rich layerBg2 A silty clay layer about 15 to 25 in down: about 45% clay, high plasticity when wet, dark gray when moist. Strong lead
- Clay-rich layerBCg1 A silty clay layer about 25 to 30 in down: about 45% clay, high plasticity when wet, gray when moist. Promising
- Clay-rich layerBCg2 A silty clay layer about 30 to 36 in down: about 45% clay, high plasticity when wet, gray when moist. Strong lead
- Clay-rich layerBCg3 A silty clay layer about 36 to 42 in down: about 45% clay, high plasticity when wet, gray when moist. Strong lead
- Clay-rich layerCgbest layer A silty clay layer about 42 to 60 in down: about 45% clay, high plasticity when wet, light brownish gray when moist. Strong lead
What it looks like raw
The clay-rich layer (Cg), 42 to 60 in down in the typical profile: light brownish gray (2.5Y 6/2); silty clay; firm. Raw colour is not fired colour.
About the soil
- Parent material: clayey glaciolacustrine deposits.
- USDA family mineralogy: illitic.
- USDA family particle-size class: fine.
- Drainage: very poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Indiana, in these survey areas: Kosciusko County, Indiana.
By state: wild clay in Indiana.
USDA, distribution and extent: The Toledo soils occur primarily in MLRA 99 in northwestern Ohio and southeastern Michigan and to a lesser extent in MLRAs 97, 98, 111B, and 111C in southern Michigan and northern Indiana. The type location is in MLRA 99. The series is of large extent, over 200,000 acres.
USDA, geographic setting: Toledo soils are on lake plains of late Wisconsinan age. Slope ranges from 0 to 2 percent. Toledo soils formed in clayey glaciolacustrine sediments. Mean annual precipitation ranges from 686 to 914 mm (27 to 36 inches). Mean annual air temperature ranges from 7 to 11 degrees C (45 to 52 degrees F). Frost-free period is 140 to 165 days. Elevation is 152 to 244 meters (500 to 800 feet) above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Del Rey: Strong lead
- Saranac: Strong lead
- Aubbeenaubbee: Promising
- Crosier: Promising
- Metea: Promising
- Miami: Promising
- Rensselaer: Promising
- Washtenaw: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Toledo silty clay, map unit To in Kosciusko County, Indiana.
- Official Series Description: Toledo(revised 09/2012), established.
- Taxonomic class: Fine, illitic, nonacid, mesic Mollic Endoaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.