Metea soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 40 to 50 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Metea soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Metea loamy sand, 0 to 2 percent slopes (Kosciusko County, Indiana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 27% clay in the fine-earth portion.
- Note USDA labels this a "2Bt2" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (17.5).
- Note Moderate thickness (about 10 in (25 cm)).
- Note Typically starts about 40 in (102 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 6% by volume).
Layer by layer
- TopsoilAp A loamy sand layer about 0 to 10 in down: about 4% clay, low plasticity when wet. Weak indication
- Sandy layerE1 A loamy sand layer about 10 to 20 in down: about 4% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerE2 A loamy sand layer about 20 to 32 in down: about 4% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Clay subsoilBt1 A sandy loam layer about 32 to 40 in down: about 18% clay, moderate plasticity when wet, yellowish brown when moist. Possible
- Clay subsoil2Bt2best layer A clay loam layer about 40 to 50 in down: about 27% clay, moderate plasticity when wet, yellowish brown when moist. Promising
- Sandy layer2C A loam layer about 50 to 60 in down: about 15% clay, moderate plasticity when wet, brown when moist. Weak indication
What it looks like raw
The clay subsoil (2Bt2), 40 to 50 in down in the typical profile: yellowish brown (10YR 5/4); clay loam; friable. Raw colour is not fired colour.
About the soil
- Parent material: sandy outwash over loamy outwash over loamy till.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Indiana, in these survey areas: Kosciusko County, Indiana.
By state: wild clay in Indiana.
USDA, distribution and extent: MLRAs 95B, 97 98, 99, 108A, 110, 111B, and 111C in northern Indiana, southern Wisconsin, northern Illinois, and southern Michigan. The series is of large extent.
USDA, geographic setting: Metea soils are on moraines and till plains. Slope ranges from 0 to 25 percent. Metea soils formed in 51 to 102 cm (20 to 40 inches) of wind or water laid sandy material and the underlying loamy till. Mean annual precipitation ranges from 762 to 1067 mm (30 to 42 inches). Mean annual temperature ranges from 8.9 to 11.7 degrees C (48 to 53 degrees F). Frost-free period is 150 to 180 days. Elevation is 183 to 466 meters (600 to 1,530 feet) above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Del Rey: Strong lead
- Saranac: Strong lead
- Toledo: Strong lead
- Aubbeenaubbee: Promising
- Crosier: Promising
- Miami: Promising
- Rensselaer: Promising
- Washtenaw: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Metea loamy sand, 0 to 2 percent slopes, map unit MbA in Kosciusko County, Indiana.
- Official Series Description: Metea(revised 11/2021), established.
- Taxonomic class: Loamy, mixed, active, mesic Arenic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.