Rensselaer soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 15 to 38 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Rensselaer soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Rensselaer spot on the map
Rated from the USDA soil survey record for Rensselaer loam, 0 to 1 percent slopes (Kosciusko County, Indiana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note USDA labels this a "Btg1" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (18).
- Note Thick enough to investigate (about 23 in (59 cm)).
- Note Typically starts within about 15 in (38 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- TopsoilAp A loam layer about 0 to 15 in down: about 21% clay, moderate plasticity when wet. Weak indication
- Clay subsoilBtg1best layer A clay loam layer about 15 to 38 in down: about 28% clay, moderate plasticity when wet, dark gray when moist. Promising
- Clay subsoilBtg2 A loam layer about 38 to 42 in down: about 24% clay, moderate plasticity when wet, gray when moist. Weak indication
- Sandy layerCg1 A stratified fine sand to silt loam layer about 42 to 76 in down: about 10% clay, moderate plasticity when wet, gray when moist. Weak indication
- Sandy layerCg2 A loam layer about 76 to 79 in down: about 13% clay, moderate plasticity when wet, gray when moist. Weak indication
What it looks like raw
The clay subsoil (Btg1), 15 to 38 in down in the typical profile: dark gray (10YR 4/1); clay loam; firm. Raw colour is not fired colour.
About the soil
- Parent material: loamy outwash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Indiana, in these survey areas: Kosciusko County, Indiana.
By state: wild clay in Indiana.
USDA, distribution and extent: MLRAs 97, 98, 99, 110, 111A, 111B, 111C, 111D, 114B, and 115A in Indiana, Illinois, Michigan, and Ohio. The series is of large extent.
USDA, geographic setting: Rensselaer soils are in depressions on till plains, stream terraces, outwash terraces, outwash plains, glacial drainage channels, and lake plains. Slope ranges from 0 to 2 percent. Rensselaer soils formed in loamy sediments. Mean annual precipitation ranges from 864 to 1118 mm (34 to 44 inches). Mean annual temperature ranges from 10.0 to 13.9 degrees C (50 to 57 degrees F). Frost-free period is 130 to 180 days. Elevation is 177 to 466 meters (580 to 1,530 feet) above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Del Rey: Strong lead
- Saranac: Strong lead
- Toledo: Strong lead
- Aubbeenaubbee: Promising
- Crosier: Promising
- Metea: Promising
- Miami: Promising
- Washtenaw: Promising
See it on the map
Open a Rensselaer spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Rensselaer loam, 0 to 1 percent slopes, map unit Re in Kosciusko County, Indiana.
- Official Series Description: Rensselaer(revised 11/2021), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Typic Argiaquolls
- Rated with rule version 2026-09-28.1; the method is on the About page.