Vesser soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 37 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Vesser soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Vesser silt loam, 0 to 2 percent slopes, occasionally flooded (Pike County, Illinois) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 20% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (14).
- Note Thick enough to investigate (about 23 in (59 cm)).
- Note Typically starts about 37 in (94 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 10 in down: about 22% clay, moderate plasticity when wet, very dark gray when moist. Possible
- Loamy layerH2 A silt loam layer about 10 to 22 in down: about 20% clay, moderate plasticity when wet, dark gray when moist. Possible
- Loamy layerH3 A silt loam layer about 22 to 37 in down: about 20% clay, moderate plasticity when wet, dark gray when moist. Possible
- Loamy layerH4best layer A silt loam layer about 37 to 60 in down: about 20% clay, moderate plasticity when wet, dark gray when moist. Possible
What it looks like raw
The loamy layer (H4), 37 to 60 in down in the typical profile: dark gray (10YR 4/1); friable. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Illinois, in these survey areas: Pike County, Illinois.
By state: wild clay in Illinois.
USDA, distribution and extent: Physiographic Division--Interior Plains
USDA, geographic setting: Parent material--alluvium
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Darwin: Strong lead
- Elco: Strong lead
- Ipava: Strong lead
- Keswick: Strong lead
- Titus: Strong lead
- Ambraw: Promising
- Baylis: Promising
- Beaucoup: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 94%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Vesser silt loam, 0 to 2 percent slopes, occasionally flooded, map unit 8396A in Pike County, Illinois.
- Official Series Description: Vesser(revised 06/2015), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Argiaquic Argialbolls
- Rated with rule version 2026-09-28.1; the method is on the About page.