Uhlig soil
Wild-clay potential
Weak indication
Weak indication: no layer of Uhlig shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Uhlig soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Uhlig ashy silt loam, 2 to 8 percent slopes (Lewis and Nez Perce Counties, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil slightly sticky and nonplastic.
- Note Thick enough to investigate (about 29 in (74 cm)).
- Note Typically starts about 39 in (99 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 4% by volume).
Layer by layer
- TopsoilA An ashy silt loam layer about 0 to 15 in down: about 14% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerBw A very fine sandy loam layer about 15 to 39 in down: about 14% clay, moderate plasticity when wet, brown when moist. Weak indication
- Sandy layerCbest layer A very fine sandy loam layer about 39 to 68 in down: about 10% clay, low plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The sandy layer (C), 39 to 68 in down in the typical profile: very pale brown (10YR 7/3) dry, brown (10YR 5/3) moist; slightly hard, very friable, slightly sticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Idaho, in these survey areas: Lewis and Nez Perce Counties, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Eastern Washington and Oregon, western Idaho; MLRA 9; moderate extent
USDA, geographic setting: Elevation--245 to 945 m
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cramont: Strong lead
- Taney: Strong lead
- Caldwell: Promising
- Latahco: Promising
- Naff: Promising
- Slickpoo: Promising
- Thatuna: Promising
- Almota: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Uhlig ashy silt loam, 2 to 8 percent slopes, map unit 138 in Lewis and Nez Perce Counties, Idaho.
- Official Series Description: Uhlig(revised 03/2026), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Vitrandic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.