Tyee soil
Wild-clay potential
Weak indication
Weak indication: no layer of Tyee shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Tyee soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Tyee gravelly loamy coarse sand, 30 to 90 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 4% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Moderate thickness (about 7 in (17 cm)).
- Note Typically starts within about 5 in (13 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 26% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A gravelly ashy loamy coarse sand layer about 0 to 5 in down: about 4% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH2best layer A gravelly coarse sandy loam layer about 5 to 12 in down: about 4% clay, low plasticity when wet, brown when moist. Weak indication
- BedrockH3 Weathered bedrock about 12 to 16 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H2), 5 to 12 in down in the typical profile: brown (10YR 5/3), dark brown (10YR 3/3) moist; soft, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum and colluvium from granitic rocks with minor amounts of loess and volcanic ash.
- USDA family particle-size class: loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 12 in (30 cm) down.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties; Chelan County Area, Washington (Parts of Chelan and Kittitas Counties).
By state: wild clay in Washington.
USDA, distribution and extent: North Central Washington. Series is of moderate extent.
USDA, geographic setting: Tyee soils are on mountainsides and ridge tops that generally have a south aspect at elevations of 1,000 to 3,600 feet, although north slope phases are recognized. Slopes are 3 to 90 percent. These soils formed in residuum, colluvium, and slope alluvium from granite, quartz diorite, granodiorite quartz monzonite, or gneiss mixed with loess and a small amount of volcanic ash in the upper part. They are in a climate with warm, dry summers and cold, moist winters. The mean annual precipitation ranges from 12 to l8 inches. The average January temperature is about 22 degrees F, the average July temperature is about 70 degrees F, and the average annual temperature is about 48 degrees F. The...
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Peoh: Promising
- Cowiche: Possible
- Morical: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Tyee gravelly loamy coarse sand, 30 to 90 percent slopes, map unit 335 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Tyee(revised 10/2002), established.
- Taxonomic class: Loamy, isotic, mesic, shallow Vitrandic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.