Tuller soil
Wild-clay potential
Weak indication
Weak indication: no layer of Tuller shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Tuller soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Tuller and Allis silt loams, 0 to 8 percent slopes (Schoharie County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 14% clay.
- Note Moderate engineering plasticity index (15).
- Note Moderate thickness (about 9 in (23 cm)).
- Note Typically starts within about 0 in (0 cm) of the surface.
- Note Few rock fragments (about 13% by volume).
Layer by layer
- Sandy layerH1best layer A silt loam layer about 0 to 9 in down: about 14% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- Sandy layerH2 A channery silt loam layer about 9 to 15 in down: about 14% clay, low plasticity when wet, grayish brown when moist. Weak indication
- BedrockH3 Unweathered bedrock about 15 to 19 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H1), 0 to 9 in down in the typical profile: very dark grayish brown (10YR 3/2); friable. Raw colour is not fired colour.
About the soil
- Parent material: loamy till derived mainly from acid sandstone, siltstone, and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy.
- Drainage: somewhat poorly drained.
- Lithic bedrock typically about 15 in (38 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in New York, in these survey areas: Schoharie County, New York.
By state: wild clay in New York.
USDA, distribution and extent: The Allegheny Plateau in southern New York and northern Pennsylvania. MLRA's 101 and 140. Tuller soils are of small extent.
USDA, geographic setting: The Tuller soils occur dominantly on long, narrow areas on hillsides and flatter hilltops that are often bordered by bedrock outcrops. Slope ranges from 0 to 8 percent. The regolith is principally a thin mantle of till dominated by material derived from acid sandstone, siltstone and thin beds of shale. The climate is humid and temperate. Mean annual rainfall ranges from 35 to 45 inches; mean annual temperature ranges from 45 to 50 degrees F.; and the frost-free period ranges from 140 to 180 days. Elevation ranges from 600 to 1750 feet above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Lakemont: Strong lead
- Phelps: Strong lead
- Holly: Promising
- Arnot: Weak indication
- Barbour: Weak indication
- Basher: Weak indication
- Bath: Weak indication
- Chippewa: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 40%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Tuller and Allis silt loams, 0 to 8 percent slopes, map unit TaB in Schoharie County, New York.
- Official Series Description: Tuller(revised 11/2013), established.
- Taxonomic class: Loamy, mixed, active, acid, mesic Lithic Endoaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.