Tucannon soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 13 to 26 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Tucannon soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Tucannon spot on the map
Rated from the USDA soil survey record for Tucannon silt loam, 7 to 25 percent slopes (Whitman County, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 22% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (10).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 13 in (33 cm)).
- Note Typically starts within about 13 in (33 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 13 in down: about 18% clay, low plasticity when wet, very dark brown when moist. Weak indication
- Loamy layerH2best layer A silt loam layer about 13 to 26 in down: about 22% clay, moderate plasticity when wet, dark brown when moist. Possible
- Loamy layerH3 A gravelly silt loam layer about 26 to 30 in down: about 22% clay, moderate plasticity when wet, brown when moist. Weak indication
- BedrockH4 Unweathered bedrock about 30 to 34 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 13 to 26 in down in the typical profile: dark brown (10YR 3/3), brown (10YR 5/3) dry; slightly hard, friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash and loess over residuum weathered from basalt.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: well drained.
- Lithic bedrock typically about 30 in (76 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Whitman County, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: Southeastern Washington, possibly eastern Oregon and northern Idaho.
USDA, geographic setting: Tucannon soils are on benches and plateaus and are in the channeled scablands. These soils formed in loess and minor amounts of volcanic ash. Slopes are 0 to 65 percent. The climate is characterized by warm, dry summers and cool, moist winters. The average annual precipitation ranges from 15 to 19 inches. The mean January temperature is about 31 degrees F, the mean July temperature is about 70 degrees F, and the mean annual temperature is about 50 degrees F. The frost-free season is 110 to 130 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Garfield: Strong lead
- Konert: Strong lead
- Latah: Strong lead
- Tilma: Strong lead
- Caldwell: Promising
- Naff: Promising
- Spofford: Promising
- Thatuna: Promising
See it on the map
Open a Tucannon spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Tucannon silt loam, 7 to 25 percent slopes, map unit 113 in Whitman County, Washington.
- Official Series Description: Tucannon(revised 10/2002), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Pachic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.