Tillicum soil
Wild-clay potential
Weak indication
Weak indication: no layer of Tillicum shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Tillicum soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Tillicum spot on the map
Rated from the USDA soil survey record for Tillicum sandy loam, 30 to 60 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 8% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 18 in (46 cm)).
- Note Typically starts about 24 in (61 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 29% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 An ashy fine sandy loam layer about 0 to 8 in down: about 10% clay, low plasticity when wet. Weak indication
- Sandy layerH2 An ashy fine sandy loam layer about 8 to 24 in down: about 10% clay, low plasticity when wet. Weak indication
- Sandy layerH3best layer A cobbly sandy loam layer about 24 to 42 in down: about 8% clay, low plasticity when wet. Weak indication
- BedrockH4 Unweathered bedrock about 42 to 46 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H3), 24 to 42 in down in the typical profile. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash over residuum and colluvium from schist or gneiss.
- USDA family particle-size class: ashy over loamy.
- Drainage: well drained.
- Lithic bedrock typically about 42 in (107 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: East slopes of the Cascade Mountains in East Central Chelan County, Washington. Series is small in extent.
USDA, geographic setting: Tillicum soils are on mountainsides with generally a northerly aspect at elevations of 1,400 to 4,800 feet. Slopes are 8 to 90 percent. These soils formed in volcanic ash over residuum and colluvium from gneiss or schist. They are in a climate with warm dry summers and cool moist winters. The average annual precipitation is 35 to 55 inches. The average January temperature is about 22 degrees F.; the average July temperature is about 63 degrees F.; the average annual temperature is 4l to 43 degrees F. The frost-free season is 70 to ll0 days. The growing season, at 28 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Open a Tillicum spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Tillicum sandy loam, 30 to 60 percent slopes, map unit 319 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Tillicum(revised 10/2002), established.
- Taxonomic class: Ashy over loamy, glassy over isotic, frigid Typic Vitrixerands
- Rated with rule version 2026-09-28.1; the method is on the About page.