Taneum soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 21 to 47 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Taneum soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Taneum loam, 30 to 60 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (12.5).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 26 in (66 cm)).
- Note Typically starts within about 21 in (53 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 26% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A loam layer about 0 to 16 in down: about 17% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Loamy layerH2 A gravelly clay loam layer about 16 to 21 in down: about 24% clay, moderate plasticity when wet, brown when moist. Weak indication
- Loamy layerH3best layer A gravelly clay loam layer about 21 to 47 in down: about 30% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerH4 An extremely cobbly clay loam layer about 47 to 58 in down: about 30% clay, moderate plasticity when wet, brown when moist. Weak indication
- BedrockH5 Unweathered bedrock about 58 to 62 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H3), 21 to 47 in down in the typical profile: brown (7.5YR 5/4), dark brown (7.5YR 3/4) moist; hard, firm, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum and colluvium from schist and gneiss mixed with loess and volcanic ash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 58 in (147 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: South central Washington. Series is of small extent.
USDA, geographic setting: Taneum soils are on uplands and mountains. Slopes are 5 to 60 percent. These soils formed in loess, weathered sandstone, and schist with minor amounts of volcanic ash. Elevations are 2,100 to 4,200 feet. The soils are in a climate of warm, dry summers and cool, moist winters. The mean annual precipitation ranges from 15 to 18 inches. The mean January temperature is 27 degrees F.; the mean July temperature is 69 degrees F.; and the mean annual temperature is 48 degrees F. The frost free season is 100 to 145 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Taneum loam, 30 to 60 percent slopes, map unit 305 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Taneum(revised 10/2002), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Typic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.