Takeuchi soil
Wild-clay potential
Weak indication
Weak indication: no layer of Takeuchi shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Takeuchi soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Takeuchi spot on the map
Rated from the USDA soil survey record for Takeuchi coarse sandy loam, 3 to 35 percent slopes (Valley Area, Idaho, Parts of Adams and Valley Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (2): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Moderate thickness (about 10 in (25 cm)).
- Note Typically starts within about 14 in (36 cm) of the surface.
- Note Few rock fragments (about 13% by volume).
Layer by layer
- TopsoilA A coarse sandy loam layer about 0 to 7 in down: about 9% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBt A coarse sandy loam layer about 7 to 14 in down: about 9% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerCbest layer A sand layer about 14 to 24 in down: about 5% clay, low plasticity when wet, brown when moist. Weak indication
- BedrockCr Bedrock about 24 to 30 in down: no clay layer to dig. Weak indication
- BedrockR Bedrock about 30 to 40 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (C), 14 to 24 in down in the typical profile: brown (10YR 5/3), dark brown (10YR 3/3) moist; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from granite over residuum weathered from granite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: somewhat excessively drained.
- Lithic bedrock typically about 30 in (76 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Idaho, in these survey areas: Owyhee County Area, Idaho; Valley Area, Idaho, Parts of Adams and Valley Counties.
By state: wild clay in Idaho.
USDA, distribution and extent: Southern Idaho. These soils are moderately extensive. MLRA 25 and 43B.
USDA, geographic setting: Takeuchi soils are on undulating to very steep sideslopes and ridges of foothills and mountains. Elevations range from 1,405 to 2,380 meters. Slopes range from 0 to 60 percent. The soils formed in residuum and colluvium from granite, quartz monzonite, other intermediate intrusive rocks. The climate is cool and moist in the winter and hot and dry in the summer. The average annual precipitation is 360 to 610 mm. The average annual temperature is 3.9 to 7.2 degrees C. The frost-free period is 55 to 100 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cabarton: Strong lead
- Chilcott: Strong lead
- Fairylawn: Strong lead
- Perla: Strong lead
- Ratsnest: Strong lead
- Succor: Strong lead
- Arbidge: Promising
- Babbington: Promising
See it on the map
Open a Takeuchi spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Takeuchi coarse sandy loam, 3 to 35 percent slopes, map unit 57 in Valley Area, Idaho, Parts of Adams and Valley Counties.
- Official Series Description: Takeuchi(revised 12/2019), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, frigid Typic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.