Babbington soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 4 to 29 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Babbington soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Babbington spot on the map
Rated from the USDA soil survey record for Babbington-Beetville loams, 0 to 3 percent slopes (Owyhee County Area, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 31% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (22): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 25 in (64 cm)).
- Note Typically starts within about 4 in (10 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- TopsoilA A loam layer about 0 to 4 in down: about 22% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Clay subsoilBtbest layer A clay loam layer about 4 to 29 in down: about 31% clay, high plasticity when wet, brown when moist. Promising
- Clay subsoilBtk A loam layer about 29 to 42 in down: about 26% clay, moderate plasticity when wet, light brownish gray when moist. Possible
- Sandy layer2C A stratified very gravelly sand to loamy sand layer about 42 to 60 in down: about 10% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 4 to 29 in down in the typical profile: brown (10YR 5/3), dark brown (10YR 3/3) moist; very hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: loamy alluvium over sandy and gravelly alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Owyhee County Area, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern Idaho. The series is of small extent. MLRA 25.
USDA, geographic setting: Babbington soils are on nearly level alluvial flats and bottomlands at elevation of 1,040 to 1,620 meters. Slopes are 0 to 3 percent. The soils formed in mixed alluvium from extrusive rocks and volcanic ash. The climate is cool and moist in the winter and warm and dry in the summer. Average annual precipitation is 250 to 330 mm and average annual temperature is 7.2 to10.0 degrees C. Frost-free period is 90 to 130 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Chilcott: Strong lead
- Fairylawn: Strong lead
- Perla: Strong lead
- Ratsnest: Strong lead
- Succor: Strong lead
- Arbidge: Promising
- Gooding: Promising
- Hades: Promising
See it on the map
Open a Babbington spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 55%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Babbington-Beetville loams, 0 to 3 percent slopes, map unit 11 in Owyhee County Area, Idaho.
- Official Series Description: Babbington(revised 02/2018), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Calciargidic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.