Succor soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 5 to 22 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Succor soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Succor-Gooding-Deshler complex, 2 to 35 percent slopes (Owyhee County Area, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 43% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (31): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 17 in (43 cm)).
- Note Typically starts within about 5 in (13 cm) of the surface.
- Note Few rock fragments (about 13% by volume).
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA A gravelly loam layer about 0 to 5 in down: about 24% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Clay subsoilBtbest layer A clay layer about 5 to 22 in down: about 43% clay, high plasticity when wet, brown when moist. Strong lead
- Loamy layerBq A loam layer about 22 to 60 in down: about 21% clay, moderate plasticity when wet, pale yellow when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 5 to 22 in down in the typical profile: brown (10YR 5/3); very hard, firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: clayey alluvium over loamy lacustrine deposits.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Owyhee County Area, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern Idaho. Succor soils are of small extent. MLRA 25.
USDA, geographic setting: Succor soils are gently sloping to steep on pediments and landslide deposits at elevations of 1,295to 1,680 meters. Slopes range from 3 to 35 percent. These soils formed in mixed alluvium from volcaniclastic material and lacustrine deposits. The climate is hot and dry in summer and cool and moist in winter. Average annual precipitation ranges from 300 to 380 mm, and average annual temperature ranges from 7.2 to 8.4 degrees C. The frost-free period is 90 to 115 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Chilcott: Strong lead
- Fairylawn: Strong lead
- Perla: Strong lead
- Ratsnest: Strong lead
- Arbidge: Promising
- Babbington: Promising
- Gooding: Promising
- Hades: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 45%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Succor-Gooding-Deshler complex, 2 to 35 percent slopes, map unit 166 in Owyhee County Area, Idaho.
- Official Series Description: Succor(revised 11/2019), established.
- Taxonomic class: Fine, smectitic, mesic Typic Palexerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.