Sylvan soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 9 to 28 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Sylvan soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Sylvan silty clay loam, 10 to 18 percent slopes, severely eroded (Pike County, Illinois) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 31% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (22): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 19 in (48 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Missing data Rock fragment content is not reported.
Layer by layer
- Loamy layerH1 A silty clay loam layer about 0 to 9 in down: about 31% clay, high plasticity when wet, dark grayish brown when moist. Promising
- Loamy layerH2best layer A silty clay loam layer about 9 to 28 in down: about 31% clay, high plasticity when wet, dark yellowish brown when moist. Promising
- Loamy layerH3 A silt loam layer about 28 to 60 in down: about 19% clay, moderate plasticity when wet, percent light brownish gray when moist. Possible
What it looks like raw
The loamy layer (H2), 9 to 28 in down in the typical profile: dark yellowish brown (10YR 4/4); friable. Raw colour is not fired colour.
About the soil
- Parent material: loess.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Illinois, in these survey areas: Pike County, Illinois.
By state: wild clay in Illinois.
USDA, distribution and extent: Illinois and Indiana. These soils have large extent in MLRA's 105, 108B, 115A, 115B and 115C.
USDA, geographic setting: Sylvan soils are on convex side slopes on loess covered till plains and risers on stream terraces. Slopes range from 2 to 60 percent on till plains and from 2 to 10 percent on the stream terraces. Sylvan soils formed in more than 203 cm (7 feet) of calcareous loess. Mean annual temperature ranges from 7.2 to 13.9 degrees C (45 to 57 degrees F), mean annual precipitation ranges from 762 to 1143 mm (30 to 45 inches), frost free days range from 140 to 200 days, and elevation ranges from 106 to 412 meters (350 feet to 1350 feet) above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Darwin: Strong lead
- Elco: Strong lead
- Ipava: Strong lead
- Keswick: Strong lead
- Titus: Strong lead
- Ambraw: Promising
- Baylis: Promising
- Beaucoup: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 94%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Sylvan silty clay loam, 10 to 18 percent slopes, severely eroded, map unit 19D3 in Pike County, Illinois.
- Official Series Description: Sylvan(revised 02/2011), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Typic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.