Surgh soil
Wild-clay potential
Weak indication
Weak indication: no layer of Surgh shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Surgh soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Surgh fine sandy loam, 3 to 30 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 8% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 25 in (64 cm)).
- Note Typically starts within about 21 in (53 cm) of the surface.
- Lowers the potential High rock content (about 47% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 An ashy fine sandy loam layer about 0 to 3 in down: about 10% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerH2 A gravelly ashy fine sandy loam layer about 3 to 13 in down: about 10% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerH3 A very gravelly sandy loam layer about 13 to 21 in down: about 8% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layerH4best layer An extremely gravelly sandy loam layer about 21 to 46 in down: about 8% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- BedrockH5 Unweathered bedrock about 46 to 50 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H4), 21 to 46 in down in the typical profile: light yellowish brown (10YR 6/4), dark yellowish brown (10YR 4/4) moist; soft, friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum, colluvium and alluvium from gneiss, schist and granite, with a mantle of volcanic ash colluvium derived from schist and/or alluvium derived from graphitic schist and/or residuum weathered f.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 46 in (117 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: East slopes of the Cascade Mountains in East and North Central Washington. This series is of small extent.
USDA, geographic setting: Surgh soils are on mountainsides, fans and broad ridgetops at elevations of 2,700 to 6,800 feet. Slopes are 3 to 90 percent. These soils formed in residuum and colluvium from granite, gneiss or schist, with a mantle of volcanic ash. They are in a climate with warm dry summers and cool moist winters. The average annual precipitation is 25 to 40 inches. The mean January temperature is about 20 degrees F.; mean July temperature is about 60 degrees F; mean annual temperature is about 39 degrees F. The growing season at 28 degrees F. is about 60 to 140 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Surgh fine sandy loam, 3 to 30 percent slopes, map unit 294 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Surgh(revised 08/2006), established.
- Taxonomic class: Loamy-skeletal, isotic Haploxerandic Haplocryepts
- Rated with rule version 2026-09-28.1; the method is on the About page.