Sunapee soil
Wild-clay potential
Weak indication
Weak indication: no layer of Sunapee shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Sunapee soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Sunapee spot on the map
Rated from the USDA soil survey record for Sunapee fine sandy loam, 3 to 8 percent slopes (Coos County Area, New Hampshire) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 27 in (69 cm)).
- Note Typically starts about 38 in (96 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 30% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A fine sandy loam layer about 0 to 8 in down: about 2% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerBs1 A gravelly fine sandy loam layer about 8 to 17 in down: about 2% clay, low plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerBs2 A gravelly fine sandy loam layer about 17 to 26 in down: about 2% clay, low plasticity when wet, strong brown when moist. Weak indication
- Sandy layerC1 A gravelly sandy loam layer about 26 to 38 in down: about 3% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerC2best layer A gravelly sandy loam layer about 38 to 65 in down: about 3% clay, low plasticity when wet, pale olive when moist. Weak indication
What it looks like raw
The sandy layer (C2), 38 to 65 in down in the typical profile: pale olive (5Y 6/3), and light olive gray (5Y 6/2); gravelly sandy loam; friable. Raw colour is not fired colour.
About the soil
- Parent material: loamy supraglacial meltout till derived from phyllite and/or granite and gneiss and/or mica schist.
- USDA family particle-size class: coarse-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 6 map units in New Hampshire, in these survey areas: Coos County Area, New Hampshire.
By state: wild clay in New Hampshire.
USDA, distribution and extent: New Hampshire, Vermont, and New York. MLRAs 143, 144A, and 144B. The series is of a moderate extent.
USDA, geographic setting: Sunapee soils are nearly level to very steep soils of the glaciated uplands, typically on backslopes and footslopes. Slope ranges from 0 to 60 percent, but is dominantly 3 to 15 percent. The soils formed in loamy melt-out till of Wisconsin age derived mainly from gneiss and schist. The climate is humid and cool. The mean annual precipitation is 790 to 1640 mm, and the mean annual temperature is 2 to 7 degrees C. The frost-free period ranges from 90 to 140 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Abenaki: Weak indication
- Adams: Weak indication
- Becket: Weak indication
- Berkshire: Weak indication
- Bucksport: Weak indication
- Charles: Weak indication
- Cohas: Weak indication
- Colton: Weak indication
See it on the map
Open a Sunapee spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Sunapee fine sandy loam, 3 to 8 percent slopes, map unit 168B in Coos County Area, New Hampshire.
- Official Series Description: Sunapee(revised 05/2016), established.
- Taxonomic class: Coarse-loamy, isotic, frigid Aquic Haplorthods
- Rated with rule version 2026-09-28.1; the method is on the About page.