Abenaki soil
Wild-clay potential
Weak indication
Weak indication: no layer of Abenaki shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Abenaki soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Abenaki spot on the map
Rated from the USDA soil survey record for Abenaki very fine sandy loam, 0 to 3 percent slopes, occasionally flooded (Coos County Area, New Hampshire) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 1% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 42 in (107 cm)).
- Note Typically starts within about 23 in (58 cm) of the surface.
- Lowers the potential High rock content (about 42% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A very fine sandy loam layer about 0 to 7 in down: about 7% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerH2 A very fine sandy loam layer about 7 to 23 in down: about 6% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layerH3best layer A very gravelly sand layer about 23 to 65 in down: about 1% clay, low plasticity when wet, light olive brown when moist. Weak indication
What it looks like raw
The sandy layer (H3), 23 to 65 in down in the typical profile: light olive brown (2.5Y 5/4); loose. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy over sandy or sandy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in New Hampshire, in these survey areas: Coos County Area, New Hampshire.
By state: wild clay in New Hampshire.
USDA, distribution and extent: New Hampshire and New York; MLRAs 143 and 144B. The series is of small extent.
USDA, geographic setting: Abenaki soils are on nearly level alluvial terraces of small, gravel-bottom rivers and brooks. Mean annual temperature ranges from 40 to 45 degrees F. Mean annual precipitation ranges from 35 to 50 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Adams: Weak indication
- Becket: Weak indication
- Berkshire: Weak indication
- Bucksport: Weak indication
- Charles: Weak indication
- Cohas: Weak indication
- Colton: Weak indication
- Croghan: Weak indication
See it on the map
Open a Abenaki spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Abenaki very fine sandy loam, 0 to 3 percent slopes, occasionally flooded, map unit 501A in Coos County Area, New Hampshire.
- Official Series Description: Abenaki(revised 09/2001), established.
- Taxonomic class: Coarse-loamy over sandy or sandy-skeletal, mixed, active, frigid Typic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.