Southwick soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 38 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Southwick soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Southwick spot on the map
Rated from the USDA soil survey record for Southwick silt loam, 12 to 25 percent slopes (Latah County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 31% clay in the fine-earth portion.
- Note USDA labels this a "Btcx" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (22): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 22 in (55 cm)).
- Note Typically starts about 38 in (97 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
Layer by layer
- TopsoilAB A silt loam layer about 0 to 18 in down: about 20% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBt/Ec A silt loam layer about 18 to 38 in down: about 15% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Clay subsoilBtcxbest layer A silty clay loam layer about 38 to 60 in down: about 31% clay, high plasticity when wet, brown when moist. Promising
What it looks like raw
The clay subsoil (Btcx), 38 to 60 in down in the typical profile: brown (10YR 5/3), and yellowish brown (10YR 5/4) dry, brown (10YR 4/3), and dark yellowish brown (10YR 4/4) moist; very hard, brittle, very firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: loess.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Idaho, in these survey areas: Latah County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Northern Idaho; MLRA 9; moderate extent
USDA, geographic setting: Elevation--520 to 1075 m
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Driscoll: Strong lead
- Garfield: Strong lead
- Latah: Strong lead
- Tilma: Strong lead
- Latahco: Promising
- Lovell: Promising
- Naff: Promising
- Thatuna: Promising
See it on the map
Open a Southwick spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Southwick silt loam, 12 to 25 percent slopes, map unit 45 in Latah County, Idaho.
- Official Series Description: Southwick(revised 06/2016), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Oxyaquic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.