Lovell soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 28 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lovell soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Lovell silt loam, 0 to 3 percent slopes (Latah County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 27% clay in the fine-earth portion.
- Note USDA labels this a "2Btc" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (18).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 32 in (81 cm)).
- Note Typically starts about 28 in (71 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
Layer by layer
- TopsoilA An ashy silt loam layer about 0 to 7 in down: about 20% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Loamy layerEc A silt loam layer about 7 to 28 in down: about 20% clay, moderate plasticity when wet, gray when moist. Possible
- Clay subsoil2Btcbest layer A silty clay loam layer about 28 to 60 in down: about 27% clay, moderate plasticity when wet, light gray when moist. Promising
What it looks like raw
The clay subsoil (2Btc), 28 to 60 in down in the typical profile: light gray (10YR 7/2), pale brown (10YR 6/3) moist; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed volcanic ash and loess over alluvium derived from metasedimentary rock.
- USDA family particle-size class: fine-silty.
- Drainage: poorly drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Latah County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Northern Idaho. The series is of small extent.
USDA, geographic setting: The Lovell soils are in the concave positions or depressions on flood plains. They formed in alluvium from loess, weathered from basalt and medisedimentary rocks mixed with volcanic ash. Elevation 2,000 to 2,800 feet. Slopes are 0 to 2 percent. The mean annual precipitation is 18 to 23 inches. The mean annual temperature is 43 to 45 degrees F. The frost-free period is 90 to 130 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Driscoll: Strong lead
- Garfield: Strong lead
- Latah: Strong lead
- Tilma: Strong lead
- Latahco: Promising
- Naff: Promising
- Southwick: Promising
- Thatuna: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lovell silt loam, 0 to 3 percent slopes, map unit 29 in Latah County, Idaho.
- Official Series Description: Lovell(revised 11/2013), established.
- Taxonomic class: Fine-silty, isotic, frigid Aquandic Epiaqualfs
- Rated with rule version 2026-09-28.1; the method is on the About page.