Snow soil
Wild-clay potential
Weak indication
Weak indication: no layer of Snow shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Snow soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Snow silt loam, 7 to 15 percent slopes (Whitman County, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 27 in (68 cm)).
- Note Typically starts about 33 in (84 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 4 in down: about 18% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerH2 A silt loam layer about 4 to 22 in down: about 20% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerH3 A silt loam layer about 22 to 33 in down: about 23% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerH4best layer A silt loam layer about 33 to 60 in down: about 23% clay, low plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The loamy layer (H4), 33 to 60 in down in the typical profile: grayish brown (10YR 5/2), very dark grayish brown (10YR 3/2) moist; slightly hard; friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium from loess and ash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Whitman County, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: Eastern Washington and Oregon, and possibly northwestern Idaho; MLRA 9. This soil is moderately extensive.
USDA, geographic setting: Snow soils are on gently sloping to moderately steep terraces and terrace side slopes at elevations of 1,800 to 3,400 feet. These soils formed in loess and alluvium from loess. Slopes are 0 to 30 percent. The summers are hot and dry and winters are cool and moist. The average annual precipitation is typically 18 to 23 inches but ranges to 13 inches in northeastern Oregon. The average annual temperature is 45 to 50 degrees F.; the average January temperature is 28 degrees F.; the average July temperature is 68 degrees F. Frost-free season is 100 to 125 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Garfield: Strong lead
- Konert: Strong lead
- Latah: Strong lead
- Tilma: Strong lead
- Caldwell: Promising
- Naff: Promising
- Spofford: Promising
- Thatuna: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Snow silt loam, 7 to 15 percent slopes, map unit 90 in Whitman County, Washington.
- Official Series Description: Snow(revised 03/2012), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Cumulic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.