Shoals soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 30 to 48 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Shoals soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Shoals loam, gravelly substratum, occasionally flooded (Kosciusko County, Indiana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 20% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (15).
- Note Thick enough to investigate (about 18 in (46 cm)).
- Note Typically starts about 30 in (76 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 12% by volume).
Layer by layer
- TopsoilAp A loam layer about 0 to 9 in down: about 19% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerC1 A loam layer about 9 to 18 in down: about 21% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerC2 A loam layer about 18 to 30 in down: about 21% clay, moderate plasticity when wet, grayish brown when moist. Possible
- Loamy layerC3,C4best layer A loam layer about 30 to 48 in down: about 20% clay, moderate plasticity when wet, grayish brown when moist. Possible
- Sandy layerC5 A gravelly loamy sand layer about 48 to 60 in down: about 8% clay, low plasticity when wet, gray when moist. Weak indication
What it looks like raw
The loamy layer (C3,C4), 30 to 48 in down in the typical profile: grayish brown (10YR 5/2); friable. Raw colour is not fired colour.
About the soil
- Parent material: loamy alluvium over sandy outwash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Indiana, in these survey areas: Kosciusko County, Indiana.
By state: wild clay in Indiana.
USDA, distribution and extent: MLRAs 97, 98, 99, 111A, 111B, 111C, 111D, 111E, 113, 114A, 114B, and 115A in Illinois, Indiana, Michigan, and Ohio. The type location is in MLRA 111A. The series is of large extent.
USDA, geographic setting: Shoals soils are on flood plains receiving sediments from areas influenced by Wisconsinan or Illinoian glaciation. Slope ranges from 0 to 2 percent. The soils formed in loamy alluvium. Mean annual precipitation ranges from 813 to 1168 mm (32 to 46 inches). Mean annual temperature ranges from 8 to 13 degrees C (47 to 55 degrees F). Frost-free period is 140 to 210 days. Elevation is 104 to 305 meters (340 to 1,000 feet) above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Del Rey: Strong lead
- Saranac: Strong lead
- Toledo: Strong lead
- Aubbeenaubbee: Promising
- Crosier: Promising
- Metea: Promising
- Miami: Promising
- Rensselaer: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Shoals loam, gravelly substratum, occasionally flooded, map unit Sn in Kosciusko County, Indiana.
- Official Series Description: Shoals(revised 11/2021), established.
- Taxonomic class: Fine-loamy, mixed, superactive, nonacid, mesic Fluventic Endoaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.